Repeated use of FROGLUBE® CLP will reduce the cleaning required and improve the lubrication performance of firearms. Proper application of FROGLUBE®  forms a durable coating which rust-proofs firearms and reduces the frequency of cleaning required.

 

APPLICATION

Use standard cleaning tools, and do not be afraid to handle FROGLUBE® with your hands. It is made of 100% biodegradable plant material and will clean & moisturize skin.

 

We recommend using a microfiber towel, which can be laundered & reused. Use it to wipe off excess FROGLUBE® before shooting.

 

Before applyingFROGLUBE®, wipe down the weapon with rubbing alcohol to remove existing solvents & oil. (this step is recommended, but may be skipped)

Clean all surfaces with FROGLUBE®. You should eliminate the use of petrochemical based cleaners & lubricants of opposing chemistry since they offset the benefits of a FROGLUBE®  treated weapon.

 

FROGLUBE® is a revolutionary product. It ?seasons' into metal & plastic parts, and releases with high heat. As the weapon is fired, the FROGLUBE®   coating prohibits carbon, lead, copper and other fouling particles from sticking and oxidation from occurring. Upon cooling, fouling particles will not stick to the weapon surfaces that are coated with FROGLUBE®  . This means your weapon will be easier to clean and you don't have to worry about getting it wet. Rust, salts, or oxidants cannot form on FROGLUBE®   coated surfaces.

 

For best results, the weapon should be warm when applying FROGLUBE®  Allow the weapon to sit in sunlight before & after initial cleanings. (or use a hair dryer) Though it can be applied at room temperature, heat increases the absorption rate. We recommend leaving FROGLUBE® on 30-60 minutes the first two times it is used. Use care when handling heated metal.

 

The more FROGLUBE® is used, the more it is absorbed which results in strengthening of the FROGLUBE®  coating. Maximum

absorption is reached when the application of additionalFROGLUBE® results in excess on the surface. When this happens, the weapon is “fully treated”. Wipe off the excess and shoot the weapon “dry”.

 

CLEANING THE WEAPON

Apply a sufficient amount of FROGLUBE® Paste or Liquid to warm firearm parts. Vigorously scrub the bore and barrel. Use it on every surface of the weapon. Metal, plastic and rubber will all benefit from FROGLUBE®

 

Use FROGLUBE® on various areas of the weapon that you would normally lubricate with gun oil. Such areas would include closely fitted and load bearing surfaces like rails, bolts, lugs & roller bearings. Wipe off any excess FROGLUBE® before shooting. For moist conditions, salt spray, water, humidity and long term storage, coat the weapon with a light to moderate covering of FROGLUBE®  and do not wipe it off.

 

After the second cleaning and lubrication with

FROGLUBE® you should find your weapon is easier to clean and will require less cleaning frequencies.

Regular use of FROGLUBE® will strengthen it's coating abilities and is recommended for all cleaning, lubrication and preservation of your firearms.

 

WARNING: IT IS NOT RECOMMENDED TO SWITCH BACK AND FORTH BETWEEN FROGLUBE®  AND OTHER PETROLEUM CLP PRODUCTS. FROGLUBE®   WILL DISSOLVE PETROLEUM ON CONTACT.

 

For addition technical product information please contact:

FROGLUBE® 619-400-7692 www.froglube.com   OR Mitch Weiss at 619-507-4503 www.froglubeclp.com  

 

 

DISTRIBUTOR CONTACT: PU-PRODUCTS LLC, CA

OFFICE: 619-334-1913  FAX: 619-334-2630

EMAIL: SALES@PU-PRODUCTS.COM